Frequent question: How strong is a c6 transmission?

It has a stall speed of 1,800 rpm and a two-wheel-drive slip yoke for its tail housing, but it doesn’t have a hard input shaft. The horsepower of the C6 stock transmission has been measured at 300 horsepower, while the torque has been rated at 250 nM.

How much power can a C6 transmission handle?

Premium Member. Yes a c6 will hold 500 hp but not a stock one with 3 high gear clutches or a stock valvebody…. A good upgrade is to remove the wave washer from the forward clutch and fit 5 plates,upgrade the high gear clutch to at least 4 but 5 is better and go with a transgo valvebody kit…

How good is a C6 transmission?

The C6 is the strongest, most durable light duty automatic Ford has made. It was designed in the 60’s during the horsepower wars. The E4OD / 4R100 is not necessarily a “crap” transmission, it is based on the C6.

Is a C6 transmission a 3-speed?

To cut down on weight and cost, the C6 featured a simple, three speed Simpson planetary gearset. To aid in shift quality and long term durability, it was the first automatic transmission designed to use the Borg-Warner flexible shift band. It had disc clutch plates instead of bands on the low and reverse gears.

IT IS INTERESTING:  Will a 2 stroke fuel damage a 4 stroke engine?

Which is better C4 or C6 transmission?

The C4 transmission was primarily used in cars. The C6 transmission could handle more power. Due to the ability to handle more power, the C6 transmission was used in many Ford trucks with bigger engines, and in larger cars that were manufactured with bigger engines.

Will a C6 transmission fit a 460?

No, C6 transmissions are engine family specific as the bellhousing & trans are a one piece casting ie, small block C6 will only fit Cleveland or Windsor, FE (390 etc) will only fit FE, & 385 series (429, 460 etc) will only fit these engines (but will also suit 351M & 400M).

Will a C6 transmission bolt a 302?

Also , will a C6 tranny fit behind a 302 ? Yes, but not the one from the FE. Best bet is out of a later model 2WD truck. Unless you’re really flogging the car, I’d not use a C6 – they’re big, heavy, and eat more HP to turn than any other of your available trans options, but they are strong.

Does a C6 transmission have overdrive?

Adding overdrive to a C6 is physically impossible, but the 4R100 can donate its forward planetary gear set for shorter first and second gear ratios. This creates a “wide-ratio” C6.

What engines bolt to a C6 transmission?

The 351m, 400, 429, 460 all bolt up to the C6 transmission without any adapters.

How do I know if my transmission is a C6?

Ascertain where the drain plug is situated at the transmission pan. If the plug is at the side of the transmission’s pan, it is the C6 but on the bottom means it’s a C4. Determine where the speedometer driver gear is located.

IT IS INTERESTING:  You asked: Are Suzuki outboard motors good?

Is the Ford C6 transmission a 4 speed?

The C6 is a non-electronic, three-speed transmission. The AOD features a four-speed, non-electronic transmission. It was not until 1992 that Ford introduced the electronic version of the AOD, the AODE.

Will a C6 transmission fit a 351W?

Registered. — No, that 351W will not bolt onto your 351M C6. — No, all 351W engines used the 351W bellhousing pattern, shared by the 302, 289, 351C, and 300-I6. — Your C6 uses a pattern shared by the 351M/400M (same engine block), and 429/460.

Car repair school