How do you test an AC fan motor?

How do I know if my AC fan motor is bad?

7 Signs and Symptoms of a Bad AC Fan Motor

  1. AC Fan Doesn’t Start. Even though you have the AC turned on, the fan does not start.
  2. AC Fan Doesn’t Stop. …
  3. Slow Rotating Blades. …
  4. Outside Fan Blades Are Still. …
  5. Rattling, Humming and Buzzing Noises. …
  6. AC Runs Intermittently. …
  7. No Cold Airflow.

What do you do when your AC fan stops working?

Turn off the AC from the thermostat and the circuit breaker. Check the fan for any debris or components it is contacting while spinning. Using your kick-start stick to manually spin the fan makes this easier. If you notice any debris, clear it out, turn everything back on, and listen to it again while it’s running.

What causes AC fan motor to burn up?

Burnt-out motor

Another common reason fans stop working is a burnt out fan motor. When fan motors are overworked – coupled with a lack of maintenance – they can tend to go bad and burn out. AC fan motors are expensive to replace and may lead to system replacement.

IT IS INTERESTING:  Quick Answer: How do you check the transmission fluid in a 2008 Saturn Vue?

Why is my AC fan not working?

If the compressor is working, but the fan won’t turn, then the problem is most likely with the motor and/or capacitor. If you don’t hear any sounds to indicate that the compressor is working, and the fan isn’t spinning, the most common causes are a lack of power or a faulty compressor contactor.

How much does it cost to replace an AC fan motor?

What’s the Cost of Repairing or Replacing a Fan Motor? The average cost of a condenser fan motor is between $300 and $500 (not including installation). If the compressor breaks, you are looking at a much costlier problem which could cost up to $2000. In some cases, your fan motor may be under warranty.

How do I know if my electric motor is bad?

How to Check an Electric Motor If It Is Bad

  1. Small fan motors last a long time due to few moving parts. Identify the type of motor and examine its nameplate information. …
  2. Ball bearings in motors can wear out without lubrication. Check for mechanical binding or seized bearings. …
  3. Power saw motors have brushes that wear out.

How do you check a motor short circuit?

You should test the windings for a “short to ground” in the circuit and open or shorts in the windings. To test your motor for short to ground, you’ll need to set the multimeter to ohms and disconnect the motor from its power source. Then inspect each wire and look for infinite readings.

How do you know if your electric motor is bad?

With a multimeter set to low ohms (usually 200), test between each winding terminal and the metal casing of the motor. If there is any reading on any of these then the motor is bad, do not use it. You may find that when it runs ungrounded that the casing becomes live at up to supply voltage.

IT IS INTERESTING:  How many amps does a window motor use?
Car repair school