How much HP can a c6 transmission handle?

Yes a c6 will hold 500 hp but not a stock one with 3 high gear clutches or a stock valvebody…. A good upgrade is to remove the wave washer from the forward clutch and fit 5 plates,upgrade the high gear clutch to at least 4 but 5 is better and go with a transgo valvebody kit…

What Motors will a C6 transmission fit?

The C6 was an automatic transmission used on engines such as the 351 Cleveland and the Ford 385 engines. Some well-known applications of the C6 transmission are the Ford Torino, Thunderbird and Mustang (This transmission has no relation the C6 Corvette).

How much HP can a C4 transmission handle?

a properly built C4 can handle as much as 800hp, though i wouldnt put that much power through one on a regular basis unless i had a strict maintenance program, including freshening up the trans at least once during the race season.

Which is better C4 or C6 transmission?

The C4 transmission was primarily used in cars. The C6 transmission could handle more power. Due to the ability to handle more power, the C6 transmission was used in many Ford trucks with bigger engines, and in larger cars that were manufactured with bigger engines.

Will a C6 transmission bolt a 302?

Premium Member. The C6 will physically bolt onto either the 289 or 302 but I don’t think it will fit the 66 tunnel without some modification to the tunnel. It should fit the 68 tunnel fine, since a big block with a C6 was available that year.

IT IS INTERESTING:  Quick Answer: What is the difference between brushed and brushless DC motor?

How do I know if my transmission is a C6?

Ascertain where the drain plug is situated at the transmission pan. If the plug is at the side of the transmission’s pan, it is the C6 but on the bottom means it’s a C4. Determine where the speedometer driver gear is located.

Will a 351c bolt to a C6 transmission?

the 351c has the big block bolt pattern just like the 460. the c6 trans. will bolt right up to your 460. No, will not work. Your thinking of the older 351M (or the cleavland) the 351c/302 will not bolt up.

Will a 390 bolt up to a C6 transmission?

No, C6 transmissions are engine family specific as the bellhousing & trans are a one piece casting ie, small block C6 will only fit Cleveland or Windsor, FE (390 etc) will only fit FE, & 385 series (429, 460 etc) will only fit these engines (but will also suit 351M & 400M).

Can you add overdrive to a C6 transmission?

Adding overdrive to a C6 is physically impossible, but the 4R100 can donate its forward planetary gear set for shorter first and second gear ratios. This creates a “wide-ratio” C6.

Car repair school