Is the 47rh a good transmission?

The 47RH is a solid piece, and that reliability extends to the later 47RE and 48RE models found in ’96-’07 Dodges. With a factory power rating of 160 hp and 400 lb-ft of torque, the Dodge four-speeds have to be fairly strong, not for the horsepower rating, but rather the torque.

Which is better 47RH or 47RE?

The stock 47RH output is much stronger than the stock 47RE output.

How much HP can a 47RH handle?

The 47RH stock in new condition is good for around 550-600 TQ , HP isn’t going to have a big impact.

Is the 47RE a good transmission?

The 47RE transmission in these trucks is not a favored transmission among Cummins owners. Some of the most common problems with this transmission involve being stuck in a gear, failure of the torque converter to lock, or hard shifts. … The 47RE uses bands to shift gears as opposed to clutch packs.

How many gears does a 47RH have?

The 47RE carries a 450 pound-feet internal torque rating, which approximates to 610 newton-meters. It has three normal gears, one overdrive gear, and reverse. The original design for the 47RE has changed little over the years, albeit with some bells and whistles added.

IT IS INTERESTING:  How much horsepower does a rotary engine have?

Will a 47RE replace a 47RH?

A stock valve body would work or any modified 47RH valve body. You would need to control the OD and lockup with switches, but the rest would work fine.

How can you tell 47RH from 47RE?

Bob, Open your hood and look up. There should be a data plate on the underside of your hood towards the front. On it you will see a series of 3 letter codes. Find the line that says Transmission, the code for the 47RE is DGP .

How much power can a Getrag 360 handle?

glhs. It can handle 500/1100 plus. If you tow a lot and heavy you will probably be putting new bearings and pilot bushings in it every 80,000 miles.

What is the difference between a 47RE and a 48RE transmission?

47RE has a different color pump. Pump is unpainted on the 47RE, and the 48RE have a black coating on them IIRC. Also the 48RE has a plastic ring on the reaction shaft support.

Is the 48RE a bad transmission?

It’s no secret that the 47RE and 48RE transmissions can be prone to countless issues. However, and in benefit, it can also be one of the most capable transmissions once built. It is for this reason that the 47RE/48RE are fertile platforms for creating a long-lasting, high quality transmission.

How much does it cost to rebuild a 47RE transmission?

Standard shop rebuild is $3000. Cheap rebuild with just kit, clutches and seals can be had for $1000 from retired shadetree builders.

How many speed is a 48RE transmission?

The 48re is a 4 speed. The only thing you can do would be to put an over/under on it.

IT IS INTERESTING:  Quick Answer: Should I call the police if my car breaks down?
Car repair school