You asked: What is an acceptable transmission temperature?

The optimal temperature range for transmission fluid is 175 to 220 degrees. Above that, for every 20 degrees bad things happen, starting with formation of varnish at 240 degrees, followed by seals hardening, plates slipping, seals and clutches burn out, carbon is formed, and, ultimately, failure.

What temp is too high for transmission?

If the temperature gets above 250 degrees F., rubber seals begin to harden, which leads to leaks and pressure losses. At higher temperatures the transmission begins to slip, which only aggravates overheating even more. Eventually the clutches burn out and the transmission calls it quits.

Is 200 degrees hot for a transmission?

The ideal temperature for your transmission is 200 degrees. For every 20 degrees past 200, the lifespan of your transmission is reduced by a factor of 2. In other words, if you hit 220 degrees, you can expect to get about half the normal life out of your transmission.

How do I lower my transmission temperature?

External Coolers

Installing an external cooler can prove greatly effective in cooling your transmission and keeping it at a regulated temperature, which helps to prevent damage. External coolers also help to reduce friction to the transmission, which is another common cause of damage.

IT IS INTERESTING:  Do you check power steering fluid with the engine on or off?

What is a dangerous transmission temp?

#1 Cause of Failure

The optimal temperature range for transmission fluid is 175 to 220 degrees. Above that, for every 20 degrees bad things happen, starting with formation of varnish at 240 degrees, followed by seals hardening, plates slipping, seals and clutches burn out, carbon is formed, and, ultimately, failure.

What do I do if my transmission is overheating?

What to do when your transmission is overheating:

  1. Stop driving immediately and let your transmission cool down.
  2. Make a note of what you were doing, where you are, what’s happening (noises, etc.)
  3. After cooling down, start back up & gingerly continue on your way.

Can a bad thermostat cause transmission problems?

If the thermostat is stuck open

Temperature gauge reads lower than normal. Heater doesn’t work. Automatic transmission has trouble shifting into higher gears. Fuel economy drops noticeably.

What temperature is too cold for transmission fluid?

Viscosity change: The viscosity of transmission fluid changes and gets thicker in the cold. The ideal temperature for it is 175 degrees, plus or minus 25 degrees, and when the transmission gets below zero degrees, it gets too thick.

Can too much transmission fluid cause overheating?

Transmission Fluid Leakage: Adding too much fluid will cause high pressure inside of your transmission. … Overheated Transmission: If there is too much fluid in your transmission, there is a good chance it will overheat. Air won’t be able to enter to cool the system down.

How do I know if my transmission is overheating?

3 Symptoms of Transmission Overheating

  1. Acrid Burning Odor. Transmissions change gears using principles of hydraulic power. …
  2. Slow Response Times. A transmission stands a much greater chance of overheating if fluid levels drop too low. …
  3. Transmission Slipping.
IT IS INTERESTING:  Is zinc good for your engine?

Can a transmission run too cool?

Heat is a huge cause of transmission failures but running too cool is bad also. Just as an engine has to run hot enough the trans has to run hot enough to get rid of any condensation that builds up inside and to keep the viscosity at the correct level for best operation.

What is to hot for a transmission?

The ideal fluid temperature is under 175 degrees, but as fluid ages it starts to break down and lose its capacity to cool down the transmission. This is when transmission overheating occurs. At 220 degrees, varnish forms. At 240 degrees, seals start to harden.

Car repair school